Back to blog

Australia’s lower aluminium welding-fume standard: what local regulators have confirmed

Australia’s aluminium welding-fume standard fell to 1 mg/m³ on November 17, 2025. Confirmed local dates in SA, Queensland and the ACT, and what is unconfirmed.

October 7, 2026. Updated November 18, 2026.

Aluminium welding fumes, expressed as aluminium, dropped from 5 to 1 mg/m³ as an eight-hour time-weighted average in the national list on November 17, 2025. Safe Work Australia announced the change in an information sheet published October 21, 2025. The sheet says the lower value matches the existing standard for welding fumes not otherwise classified, and that aluminium welding is widely used in boat building and repair.

The November 2025 WES list records the amendment, and the gravimetric value takes the list’s default inhalable basis. The aluminium welding-fume record keeps that national date separate from local commencement, which we rechecked on November 18, 2026.

Dated local confirmations

South Australia gives the earliest date we found. SafeWork SA says the lower aluminium value applies from November 17, 2025, the same day as the national list.

WorkSafe Queensland reported on December 2, 2025 that the 1 mg/m³ standard was now in effect, without giving a start date.

The ACT set a later date. Its declaration NI2026-340 adopts the November 2025 WES list from September 9, 2026, almost ten months after the national change. Our ACT story covers that commencement.

Stated without a date

SafeWork NSW and WorkSafe Victoria both describe the 1 mg/m³ aluminium value as current, but neither page gives a start date. Western Australia’s new exposure-limit regulations, SL 2026/230, adopt the November 2025 WEL list from December 1, 2026, and that list carries the 1 mg/m³ entry. We did not confirm the Western Australian value before that date.

We could not confirm dates for Tasmania, the Northern Territory or the Commonwealth. For Queensland mines and quarries, Schedule 5 of the Mining and Quarrying Safety and Health Regulation 2017 keeps a single welding-fumes entry at 5 mg/m³, and we did not confirm how that entry applies to aluminium welding. Queensland coal and NSW mines were not checked for this substance.

Comparing past samples

The national WEL list that is due to start on December 1, 2026 keeps aluminium welding fumes at 1 mg/m³, and no jurisdiction we checked has given it a separate transition.

APT’s practical interpretation is to compare older samples with the value that applied locally on the sample date, and to attach the local instrument and its start date to any aluminium result that is re-assessed against the new value. The fraction and the expression as aluminium should stay with the number. Other fume components and extended shifts may need their own assessment, and the list change sets no sampling frequency.

Related Australian records, including the general welding-fume change, are in the industrial hygiene regulatory tracker.

Get regulatory news updates

Receive updates on industrial hygiene and workplace exposure regulations in the US, Canada, and Australia.

Take a tour of APT's dust management platform

Vulcan Materials Company is the nation’s largest producer of construction aggregates.

Project partner

Brent Leclerc | Environmental Manager

Problems solved

Unjustified community dust complaints & lawsuits

Difficulty complying with opacity regulations and risk of NOVs

Solution

Real-time dust monitoring

Dust maps proving no community impact, preventing fines & lawsuits

Real-time opacity monitoring, high degree of compliance

Case study overview

Share this article

Better decisions start with real-time insight

APT helps industrial teams move faster, act smarter, and stay compliant—because when you can see the problem clearly, you can solve it confidently.