Back to blog

Quebec’s delayed Schedule I limits for five substances took effect March 1, 2026

Quebec’s delayed RSST Schedule I values for asphalt fumes, cadmium, chromium VI and two other substances took effect March 1, 2026. Values and later changes.

October 7, 2026. Updated November 18, 2026.

Five air-contaminant entries in Schedule I of Quebec’s Regulation respecting occupational health and safety (RSST) took effect on March 1, 2026, almost two years after the rest of the amendment that introduced them. Décret 280-2024 was published in the Gazette officielle du Québec on February 28, 2024 and came into force on the 15th day after publication, March 14, 2024. Its section 3 held back the changes for asphalt fumes, respirable cadmium, water-soluble inorganic chromium VI compounds, diethylene glycol monobutyl ether and ethyl 2-cyanoacrylate until March 1, 2026.

Section 40 of the RSST prohibits worker exposure in an establishment beyond the Schedule I limits, and section 2 applies section 40 to construction sites as well. APT’s Quebec staged exposure-limit record lists both commencement dates and the later 2026 amendment.

The five values now in force

The Légis Québec consolidation of the RSST, up to date to July 1, 2026, shows the entries below. A VEMP is an average over an eight-hour day in a 40-hour week, and a VECD is a 15-minute short-term value.

  • Asphalt fumes, expressed as the benzene-soluble fraction of particulate and vapour, have a VEMP of 1.5 mg/m³ measured as total particulate.
  • Elemental cadmium and its compounds, expressed as Cd, have a VEMP of 0.005 mg/m³ in the respirable fraction.
  • Water-soluble inorganic chromium VI compounds, expressed as Cr, have a VEMP of 0.005 mg/m³.
  • Diethylene glycol monobutyl ether has a VEMP of 10 ppm, with the notation for the inhalable fraction and vapour.
  • Ethyl 2-cyanoacrylate has a VEMP of 0.2 ppm and a VECD of 1 ppm.

The table also keeps a separate 0.01 mg/m³ cadmium entry that has no respirable notation.

A 2026 amendment changed wording and left the values alone

Décret 1305-2026 was published in the Gazette on August 26, 2026 and took effect on September 10, 2026. Its section 21 retitles Schedule I to refer to air contaminants and rewords notes 15 and 16 of the schedule. It changes no values.

Section 9 of the same regulation replaces the reference in RSST section 45.1 to CAN/CSA-Z94.4-11, as published in September 2016, with an undated reference to CSA Z94.4 on selecting, using and caring for respirators. The rule that employer-supplied respirators be certified by NIOSH or the CSA, which Décret 280-2024 added to section 45.1, is unchanged.

The Légis Québec text is current only to July 1, 2026, so it still shows the 2016 CSA reference. Until Décret 1305-2026 is consolidated, the two texts have to be read together. APT found no other adopted RSST amendment in the weekly issues of Part 2 of the Gazette from June 3 to November 18, 2026.

The November draft repeats these values

On November 11, 2026, the CNESST published a draft regulation that would replace the whole Part 1 table of Schedule I. The draft table carries all five values above without change. It has no legal effect until it is adopted and approved. APT covers the proposed changes in Quebec draft would lower RSST limits for benzene, xylene and hardwood dust.

Checking records that span 2024 to 2026

In APT’s reading, an exposure register that covers this period should show March 1, 2026 beside the five entries, since the earlier entries for those substances applied until that date. A respiratory protection program written to the 2016 edition of CSA Z94.4 can be reviewed against the undated reference that has applied since September 10, 2026.

Other Canadian exposure-limit changes are listed in the industrial hygiene regulatory tracker.

Get regulatory news updates

Receive updates on industrial hygiene and workplace exposure regulations in the US, Canada, and Australia.

Take a tour of APT's dust management platform

Vulcan Materials Company is the nation’s largest producer of construction aggregates.

Project partner

Brent Leclerc | Environmental Manager

Problems solved

Unjustified community dust complaints & lawsuits

Difficulty complying with opacity regulations and risk of NOVs

Solution

Real-time dust monitoring

Dust maps proving no community impact, preventing fines & lawsuits

Real-time opacity monitoring, high degree of compliance

Case study overview

Share this article

Better decisions start with real-time insight

APT helps industrial teams move faster, act smarter, and stay compliant—because when you can see the problem clearly, you can solve it confidently.